| Simply the Most, Simply the Best!
Wonder Products for High Fidelity ... |
Wonder DynamiCap New!DynamiCap-More dynamic, More transparent, more musically natural! 更多動態, 更加透明, 多些音樂自然性! DynamiCap Installation Hints 按裝指點說明 Recommended Cap Directionality: 
Loudspeaker version (“L” added on label): Shorter lead wire is input or plus end. If you reverse this, trebles will be softer. Electronics version: Longer lead wire is input or plus end. If you reverse this, trebles will be harder and midranges will be less airy. If cap is used in a feedback loop or in the negative polarity part of a balanced circuit, the sonically optimum direction might be reversed; you should experiment to see which cap direction sounds better. • Damping blanket coating. When fully cured, DynamiCap’s integral damping coating is dry and relatively hard to the touch, but internally it is still pliable, and it has a great molecular affinity for itself, with long chain molecular intertwining (which is why it is so effective at damping). This means that plural DynamiCaps should not be jumbled in a parts bin, or pressed together for an extended period of time prior to assembly. The coating’s molecular affinity for itself can cause two caps to grow together over time, if they are left pressed together for an extended period (note that even two pieces of metal can fuse together if their bare faces are left together). We ship DynamiCaps with separators between caps, and it is advisable to keep the caps separated until you are ready to install them. Of course, if you do want to jumble DynamiCaps in a parts bin, or store them in rows right next to each other, simply ask for the mylar tape wrap packaging option. .01 uF Special Handling: 
The .01 uF (in the standard hotrod/hobbyist version) does not have its wire leads anchored by epoxy, so the cap’s tin foil body can tear (where the wire lead is soldered to it) if you handle the cap roughly or bend its leads while holding its body. If you want to bend one of its wire leads, hold that lead near cap body with needle nose pliers as shown, while bending lead farther from cap body. We also make ruggedized versions, including cast epoxy ends to anchor the leads, so they can be bent without special care. 
如有問題或需要建議,請電詢 |
| |
| Last updated on 0ˇ/23/03 |